Napoleon-grills LD485RB Manuel d'utilisateur télécharger pdf (Page 10)

www.napoleongrills.com

of the burner. Shake any loose debris from the burner through the gas inlet. Check the burner ports and valve

orices for blockages. Burner ports can close over me due to cooking debris and corrosion, use an opened pa

perclip

or the supplied port maintenance bit to clean them. Drill out blocked ports using this drill bit in a small cord

less

drill. The ports are easier to clean if the burner is removed from the grill, but it can also be done with the

burner installed. Do not ex the drill bit when drilling the ports, as this will cause the drill bit to break. This drill

is for burner ports only, not for the brass orices (jets) which regulate the ow into the burner. Take care not to

enlarge the holes. Ensure the insect screen is clean, ght, and free of any lint or other debris.

Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when

installing.

WARNING! When reinstalling the burner aer cleaning it is very

important that the valve/orice enters the burner tube before lighng your

gas grill. If the valve is not inside the burner tube a re or explosion could

occur.

Troubleshoong

Problem Possible Causes Soluon

Low heat / Low ame

when valve turned to

high.

For propane - improper lighng procedure.

For natural gas - undersized supply line.

For both gases - improper preheang.

Ensure lighng procedure is followed

carefully. All gas grill valves must be in the

o posion when the tank valve is turned

on. Turn tank on slowly to allow pressure

to equalize. See lighng instrucons.

Pipe must be sized according to

installaon code.

Preheat grill with both main burners on

high for 10 to 15 minutes.

Excessive are-ups/

uneven heat.

Sear plates installed incorrectly.

Improper preheang.

Excessive grease and ash build on sear plates

and in drip pan.

Ensure sear plates are installed with the

holes towards the front and the slots on

the boom. See assembly instrucons.

Preheat grill with both main burners on

high for 10 to 15 minutes.

Clean sear plates and drip pan regularly.

Do not line pan with aluminum foil. Refer

to cleaning instrucons.

Burners burn with yellow

ame, accompanied by

the smell of gas.

Possible spider web or other debris, or

improper air shuer adjustment.

Thoroughly clean burner by removing.

See general maintenance instrucons.

Open air shuer slightly according to

combuson air adjustment instrucons.

(This must be done by a qualied gas

installer.)

Aluminum Casngs: Clean casngs periodically with warm soapy water. Aluminum will not rust, but high

temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white spots

on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the surface to

remove any residue and paint with high temperature barbecue paint. Protect surrounding areas from over-

spray.

Follow the manufacture’s direcons for curing.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Napoleon-grills LD485RB Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Grilles Napoleon-grills LD485RB